11-29-2019, 10:38 PM
I just installed the 128G module which comes with android 7.1.2 installed on it (not sure why). Anyway, I've been reading through the threads about how the new factory image is available which is great. Here's what happened.
1. booted to the SD but the power light just flashed. Nothing from there.
2. flipped the onboard switch to disable the eMMC.
3. booted from SD.
4. flipped the onboard switch to enable the eMMC.
5. looked to see if the eMMC was available but no dice.
6. rebooted and ended up back at step 1.
7. Reaching out for help
While I'm writing this, I'm flashing the latest build to a USB to see if I can go that route. If this proves to be successful, what are the steps I need to take to dd the image to the eMMC? I am a noob but not afraid of the command line.
Thanks in advance.
1. booted to the SD but the power light just flashed. Nothing from there.
2. flipped the onboard switch to disable the eMMC.
3. booted from SD.
4. flipped the onboard switch to enable the eMMC.
5. looked to see if the eMMC was available but no dice.
6. rebooted and ended up back at step 1.
7. Reaching out for help
While I'm writing this, I'm flashing the latest build to a USB to see if I can go that route. If this proves to be successful, what are the steps I need to take to dd the image to the eMMC? I am a noob but not afraid of the command line.
Thanks in advance.