PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Dead pinecil

Dead pinecil
joelspangler
Pine Initiate
**
Joined: Dec 2020
Posts: 5

Reputation: 2
#3
02-09-2021, 09:16 PM
I clicked through the scary invalid security cert for https://support.pine64.org/ which forwarded me to pine's zoho support site. I opened a case to see what my options are. If someone from pine sees this, you should either update your security cert to include the above link, or change the link on the warranty page to go directly to the zoho support site.
  Reply


Messages In This Thread
Dead pinecil - by joelspangler - 02-08-2021, 08:26 PM
RE: Dead pinecil - by Julius_GU - 02-09-2021, 12:51 PM
RE: Dead pinecil - by joelspangler - 02-09-2021, 09:16 PM
RE: Dead pinecil - by zer0sig - 02-12-2021, 06:40 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  pinecil v2 dosent negotiate power moses 0 344 07-07-2026, 07:28 AM
Last Post: moses
  Pinecil low temp mods? davidcoley 0 493 06-21-2026, 02:53 AM
Last Post: davidcoley
  my pinecil v2 is not working jagrav 0 901 04-17-2026, 06:28 AM
Last Post: jagrav
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 1 2,869 03-28-2026, 02:37 AM
Last Post: Juptin
  Pinecil v2: Use car battery for power? FZB 0 896 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 1,296 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 1,592 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,671 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 9,485 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 5,845 05-15-2025, 10:41 AM
Last Post: dreieck

Forum Jump:


Users browsing this thread: 1 Guest(s)