PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Dead short on the power input of the Pinecil

Dead short on the power input of the Pinecil
m42uko
Pine Initiate
**
Joined: Nov 2019
Posts: 9

Reputation: 4
#2
01-18-2021, 02:07 PM
Just a quick update: I removed the RT7272B from the board, and indeed, it's the cause. There's a short inside the IC from VCC to SW to GND. Now I just have to hope that VCC didn't short to SW first and that the rest is fine... and find a replacement part.
  Website
  Reply


Messages In This Thread
RE: Dead short on the power input of the Pinecil - by m42uko - 01-18-2021, 02:07 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  pinecil v2 dosent negotiate power moses 0 344 07-07-2026, 07:28 AM
Last Post: moses
  Pinecil low temp mods? davidcoley 0 493 06-21-2026, 02:53 AM
Last Post: davidcoley
  my pinecil v2 is not working jagrav 0 901 04-17-2026, 06:28 AM
Last Post: jagrav
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 1 2,869 03-28-2026, 02:37 AM
Last Post: Juptin
  Pinecil v2: Use car battery for power? FZB 0 896 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 1,296 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 1,592 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,671 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 9,485 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 5,845 05-15-2025, 10:41 AM
Last Post: dreieck

Forum Jump:


Users browsing this thread: 1 Guest(s)