PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Pinecil V2 doesn’t power on under any circumstances

Pinecil V2 doesn’t power on under any circumstances
Juptin
Pine Initiate
**
Joined: Mar 2026
Posts: 1

Reputation: 0
#2
03-28-2026, 02:37 AM
Sorry to not really add anything other than I have similar issues. Bought in February. Never used the iron functions. Updated the firmware to adjust the settings. Plugged it back into the PC a couple of times since, no problems, usual display. Plugging it in now gives me nothing, even when I hold the minus to get to the firmware flash screen. Totally dead. I was told by support to post info here so I thought Id jump on here.
  Reply


Messages In This Thread
RE: Pinecil V2 doesn’t power on under any circumstances - by Juptin - 03-28-2026, 02:37 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  my pinecil v2 is not working jagrav 0 280 04-17-2026, 06:28 AM
Last Post: jagrav
  Pinecil v2: Use car battery for power? FZB 0 493 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 921 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 1,136 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,338 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 9,077 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 5,168 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil v2 issue autumnharris 0 1,399 05-15-2025, 01:35 AM
Last Post: autumnharris
  Pinecil constantly cutting out WroughtIron 1 3,126 01-16-2025, 02:20 AM
Last Post: D4veC4rter
Exclamation Pinecil is working with 5v but nothing else!! MizterPink 1 2,163 01-07-2025, 03:59 PM
Last Post: MizterPink

Forum Jump:


Users browsing this thread: 1 Guest(s)