+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinecil (https://forum.pine64.org/forumdisplay.php?fid=162)
+--- Forum: General Discussion on Pinecil (https://forum.pine64.org/forumdisplay.php?fid=163)
+--- Thread: Pinecil V2 doesn’t power on under any circumstances (/showthread.php?tid=19747)
Pinecil V2 doesn’t power on under any circumstances - BigCarrotLeaf - 03-22-2025
Hello everone!
I bought a pinecil v2 a few months ago, but I have only needed to use it once since I own it.
Yesterday I wanted to use it again, but I had to found out it don’t power on.
I tried with both barrel jack, and USB-C via 5-12-20V, also from two different cables.
While I hoped its firmware can be updated at least, from my PC, it doesn’t even recognised my device.
When I opened it up, everything looked normal, the joints were fine, nothing blown up.
Personally I’m a plain user not an engineer, though my assumption is that it is completely dead.
I would like to ask, what can I do in this case? Is there anything my attention passed on?
If it’s dead, I have any chance to repair?