08-25-2022, 06:08 AM
(This post was last modified: 08-25-2022, 06:13 AM by elitegamercody.)
I was able to reimagine the eMMC with a Pinebook Pro Manjaro image but I only make it to the U-Boot screen. If I try to boot any Manjaro kernel my system enters a kernel panic.
I can drop to the U Boot console but I can’t access or determine the mount point of the SD card so I may install Tow-Boot to the SPI. Can someone just post a functioning Manjaro image so I can see if I may boot from that? I have the switch set away from the display in order to not prioritize eMMC booting but I can’t seem to boot from the SD card.
Is there any place Pine hosts the factory eMMC image, so I may just return my device to factory? My backup causes kernel panics so I am concerned the drive I flashed the backup image to is faulty and I no longer have a backup to use.
Everyone would appreciate the ability to reset the device.
Is the factory UBoot image on the SPI only able to boot the factory image? Is that some one-off checksum that is irretrievably lost if your backup gets corrupted?
I can drop to the U Boot console but I can’t access or determine the mount point of the SD card so I may install Tow-Boot to the SPI. Can someone just post a functioning Manjaro image so I can see if I may boot from that? I have the switch set away from the display in order to not prioritize eMMC booting but I can’t seem to boot from the SD card.
Is there any place Pine hosts the factory eMMC image, so I may just return my device to factory? My backup causes kernel panics so I am concerned the drive I flashed the backup image to is faulty and I no longer have a backup to use.
Everyone would appreciate the ability to reset the device.
Is the factory UBoot image on the SPI only able to boot the factory image? Is that some one-off checksum that is irretrievably lost if your backup gets corrupted?