PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Real/Usable USB-C battery pods for Pinecil? (9-12v mode minimum)

Real/Usable USB-C battery pods for Pinecil? (9-12v mode minimum)
biketool
Pine Scholar
****
Joined: Sep 2020
Posts: 414

Reputation: 31
#16
08-04-2022, 05:18 AM
(08-02-2022, 10:13 PM)Flux-Sniffer Wrote: I'm using a Baseus 65W 30,000mAh power bank.  It was pricey, but lasts for ages.  It heats the Pinecil to 340c in about 12 seconds using the red Pincil silicone USB C cable.

Several IP5328 boards have arrived, I have some 18650 cells so I will decide how best to construct a Pinecil compatible battery pod.  It is unfortunate that this process of selection is so fraught, though at least there are some tested off-the-shelf options vs bring-your-own cells options.
  Reply


Messages In This Thread
RE: Favorite USB-C batteries? - by biketool - 12-20-2021, 11:53 AM
RE: Favorite USB-C batteries? - by VaZso - 12-22-2021, 06:16 PM
RE: Favorite USB-C batteries? - by biketool - 12-23-2021, 10:08 AM
RE: Favorite USB-C batteries? - by VaZso - 12-25-2021, 05:17 AM
RE: Favorite USB-C batteries? - by biketool - 03-10-2022, 02:38 PM
RE: Favorite USB-C batteries? - by biketool - 04-23-2022, 01:26 PM
RE: Real/Usable USB-C battery pods for Pinecil? (9-12v mode minimum) - by biketool - 08-04-2022, 05:18 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Pinecil constantly cutting out WroughtIron 0 92 11-15-2024, 10:37 AM
Last Post: WroughtIron
  Help with Pinecil saranelson 1 128 11-09-2024, 02:19 PM
Last Post: biketool
  pinecil v2 reverse polarity issue adamsk1952 0 353 09-12-2024, 07:54 AM
Last Post: adamsk1952
Sad Pinecil V2 screw broken! Carol8 1 215 09-09-2024, 08:44 AM
Last Post: Carol8
  Pinecil on Amazon? WEF 5 1,638 09-05-2024, 08:23 AM
Last Post: Jeb
Question Pinecil v2 power cycles at higher voltages? clemon79 3 2,153 08-10-2024, 05:47 AM
Last Post: RevAngel
Question Can Pinecil Read USB-C Cable E-Marker Chips? Garywoo 1 693 05-13-2024, 01:31 PM
Last Post: tllim
  Connecting a power supply to the Pinecil jon_bondy 1 989 02-29-2024, 07:37 PM
Last Post: Okedokey
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 2 1,507 01-31-2024, 12:34 AM
Last Post: suga7
Question Pinecil Tempaerature Reading jumps to Y400°C when active but stays normal when cold H3wastooshort 0 707 12-24-2023, 05:45 PM
Last Post: H3wastooshort

Forum Jump:


Users browsing this thread: 1 Guest(s)