PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Pinecil cuts out / reboots during soldering

Pinecil cuts out / reboots during soldering
metnetdave
Pine Initiate
**
Joined: Nov 2021
Posts: 3

Reputation: 0
#16
11-23-2021, 06:45 AM (This post was last modified: 11-23-2021, 06:45 AM by metnetdave.)
My UK one is only two pin connection to the power supply, so no Ground/earth on the psu

It does look like a psu issue  @pine64  any ideas for a solution the combination of Pinecil and pine power is unworkable?
  Reply


Messages In This Thread
RE: Pinecil cuts out / reboots during soldering - by metnetdave - 11-23-2021, 06:45 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 60 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 625 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 3,971 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 8,570 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 4,182 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil v2 issue autumnharris 0 1,034 05-15-2025, 01:35 AM
Last Post: autumnharris
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 0 1,544 03-22-2025, 07:29 AM
Last Post: BigCarrotLeaf
  Pinecil constantly cutting out WroughtIron 1 2,329 01-16-2025, 02:20 AM
Last Post: D4veC4rter
Exclamation Pinecil is working with 5v but nothing else!! MizterPink 1 1,632 01-07-2025, 03:59 PM
Last Post: MizterPink
  Pinepower suitable for an s23 (and a pinecil) its_lieseeeee 0 1,263 12-09-2024, 01:41 PM
Last Post: its_lieseeeee

Forum Jump:


Users browsing this thread: 1 Guest(s)