Problem booting Pinebook Pro

[gimy16]

Hi!

I'd installed Manjaro 20.04 in my PBP; I did all the mirrorlist change stuff, and I shut it down 2 days ago. Today when I was going to boot it, a red light has shown and it is not opening or doing anything else.

When I try to reinstall the Manjaro 20.04 I pressed ES after 15-20 seconds and there is a black window with blank letters that say:
"[5.102225] EXT4-fs error (device mmcblk1p2): ext4_journal_check_start:84etected aborted journal
[5.103046] EXT4-fs (mmcblk1p2): Remounting filesystem read-only"

Today I tried to disable eMMc and installing Manjaro again but the problem persists. I have only been able to mount the Default Debian image from an SD card, but I don't know how to reinstall it to the eMMc or try to boot the eMMc another way... Any ideas?

Thanks very much!

---

Hi!

I'd installed Manjaro 20.04 in my PBP; I did all the mirrorlist change stuff, and I shut it down 2 days ago. Today when I was going to boot it, a red light has shown and it is not opening or doing anything else.

When I try to reinstall the Manjaro 20.04 I pressed ES after 15-20 seconds and there is a black window with blank letters that say:
"[5.102225] EXT4-fs error (device mmcblk1p2): ext4_journal_check_start:84: Detected aborted journal
[5.103046] EXT4-fs (mmcblk1p2): Remounting filesystem read-only"

Today I tried to disable eMMc and installing Manjaro again but the problem persists. I have only been able to mount the Default Debian image from an SD card, but I don't know how to reinstall it to the eMMc or try to boot the eMMc another way... Any ideas?

Thanks very much!

[waweic]

Did you check the integrity of the image you downloaded? Maybe using another SD-card might help too.

[Dendrocalamus64]

Besides quoting it, you can check the "Disable Smilies" checkbox when posting or editing the post to stop it from turning :D :P &c into emoji.

[gimy16]

Did you check the integrity of the image you downloaded? Maybe using another SD-card might help too.

I tried to use another image and using another SD-card, the result was the same.

Then I contacted with the Pine64 support, and finally they said that it could be problem of the motherboard and that I had to change it.

[gimy16]

Finally I got an USB to eMMC adapter from Pine64, I connect thee eMMC of my PBP to my PC and it was empty! So I downloaded the Manjaro image again, and I installed it into the eMMC using etcher; probably I did something wrong in order to erase all the data froom the eMMc; but now it's solved!

Thanks to all the community for the support!