Manjaro Arm i3 HELP

[HaxNet]

Hey guys,

I just got my PBP last night and I flashed the new 128GB emmc with the image. Put it in the PBP, boot up, went through username/pw, locale, etc., It auto reboots.
It just stays in a black screen. So I went to tty1-6 and switch it back to tty7, the login screen is there, but can't move the mouse or type. So i tried to type and then switch back to tty6 and back, tty7 recognizes it. I had to keep switching back and forth back and forth. 

Has anyone tested i3 on the new batch of PBP? 

I also try to run the i3 via sd, but it does the exact same thing.

any ideas?

[e-minguez]

Hey guys,

I just got my PBP last night and I flashed the new 128GB emmc with the image. Put it in the PBP, boot up, went through username/pw, locale, etc., It auto reboots.
It just stays in a black screen. So I went to tty1-6 and switch it back to tty7, the login screen is there, but can't move the mouse or type. So i tried to type and then switch back to tty6 and back, tty7 recognizes it. I had to keep switching back and forth back and forth. 

Has anyone tested i3 on the new batch of PBP? 

I also try to run the i3 via sd, but it does the exact same thing.

any ideas?

See https://forum.manjaro.org/t/pinebook-pin.../133927/10

Basically it was an issue with the console, try to update to latest or reinstall with 20.06 which was released a few days ago.

[HaxNet]

Hey guys,

I just got my PBP last night and I flashed the new 128GB emmc with the image. Put it in the PBP, boot up, went through username/pw, locale, etc., It auto reboots.
It just stays in a black screen. So I went to tty1-6 and switch it back to tty7, the login screen is there, but can't move the mouse or type. So i tried to type and then switch back to tty6 and back, tty7 recognizes it. I had to keep switching back and forth back and forth. 

Has anyone tested i3 on the new batch of PBP? 

I also try to run the i3 via sd, but it does the exact same thing.

any ideas?

See https://forum.manjaro.org/t/pinebook-pin.../133927/10

Basically it was an issue with the console, try to update to latest or reinstall with 20.06 which was released a few days ago.

Thanks, I literally went through a bunch of threads and found the 20.06. I will give it a try and report back.

[HaxNet]

I used the new release and still the same. I have to keep going back and forth tty6 and tty7 to see any movements