Another one boots to black screen

[Sb2024]

I got my pine book pro back in march, put towboot on the spi and ran armbian from the emmc. Happy! After a period of disuse including full battery discharge, it started booting to a black screen. Sad! 

I put a new image of armbian on an SD card and it does the same thing. I opened the case and turned off the emmc switch and tried a fresh SD card. No change. I tried the long press hard reset. Same. 

Tow boot is still working. When it boots to the black screen, the power light is green and the caps lock and num lock lights work. 

I’m not sure what to do next.

[KC9UDX]

Well, you could zero the SPI ROM, have the eMMC disabled, and boot to the SD card, assuming the SD card actually boots.

[Sb2024]

Towboot on the spi is the only thing that is working correctly. It does not boot to the SD card.

[Sb2024]

I think I’m going to replace the main board and emmc. Maybe a power surge from fully discharging the battery fried something.

I could not find another case like mine where the boatload works and nothing else does.

[wdt]

With a black screen I'm not sure how you could manage to zero SPI
Armbian AFAIK starts a ssh session, so if you can find the IP address.....
OR if that doesn't work (no wifi connect) plug a usb-ethernet dongle and ethernet in

[Sb2024]

I was able to get it to boot with a usb drive with the original version of armbian that was previously working. Version 24.2.1, current 6.6.16, gnome desktop.

I will attempt the Sd card with this image and also will attempt to install on the emmc again.

[Sb2024]

Works with the sd card too. Appears the most current version of armbian is broken compared to this version.

[Sb2024]

Back booting from emmc. Happy. My issue was caused by a bad image of armbian. Thank you to the very chatgtp type response telling me to try other versions.