09-03-2021, 05:16 AM
If you are 100% sure it is fully connected to the charger (those springs on the back of the case are relatively strong and one can lift the back away from the other if you are using a tape or a weak glue) then the next step would be to check the battery and regulator voltages with a multimeter.
Battery is easy since the pads are pretty obvious (expect ~3.7v), you can check the regulator voltage by testing the GND and 3V3 from the SWD connector (see https://wiki.pine64.org/wiki/PineTime_Devkit_Wiring ).
Battery is easy since the pads are pretty obvious (expect ~3.7v), you can check the regulator voltage by testing the GND and 3V3 from the SWD connector (see https://wiki.pine64.org/wiki/PineTime_Devkit_Wiring ).