cad files for rear case/battery upgrade

[dallytaur]

I'm looking for the cad file for the rear case so I can 3d print and give the phone a huge battery.

Also, how would I go about adding a new battery? Could I get a polymer battery, but how would I wire in the thermistor and protection and what part would that be? would be better to wire into the Vbus pongo pin?

3D File
https://files.pine64.org/doc/datasheet/p...0Cover.stp
Found here
https://wiki.pine64.org/index.php?title=PinePhone
Which is probably a good place to start for your battery questions. Also xnux.eu is another hardware entry place.

HTH
LF

thanks I've been I just need to find a way of wringing a battery is the temp sensor required for the charger and if it is how do I wire it in. do I geta 100k thermistor and wire it it?