PineTime case
I ordered a 3D print of the case and it looks good.
Unlike the model, mine came without the bridge over the button - maybe it's for the best. The button is easier to push than if it was surrounded on all sides.
The back fits snug to the body and the watch doesn't gain that much bulk. The case doesn't sit uncomfortably - there aren't sharp edges that would sink into the hand.
I don't have the original charger but just touching the pins starts the charging. All good so far.
Here are a few pics:
https://drive.google.com/file/d/1nISusI9...p=drivesdk
https://drive.google.com/file/d/1nZuVojo...p=drivesdk
https://drive.google.com/file/d/1n_lnr99...p=drivesdk
https://drive.google.com/file/d/1nKWyryW...p=drivesdk
Unlike the model, mine came without the bridge over the button - maybe it's for the best. The button is easier to push than if it was surrounded on all sides.
The back fits snug to the body and the watch doesn't gain that much bulk. The case doesn't sit uncomfortably - there aren't sharp edges that would sink into the hand.
I don't have the original charger but just touching the pins starts the charging. All good so far.
Here are a few pics:
https://drive.google.com/file/d/1nISusI9...p=drivesdk
https://drive.google.com/file/d/1nZuVojo...p=drivesdk
https://drive.google.com/file/d/1n_lnr99...p=drivesdk
https://drive.google.com/file/d/1nKWyryW...p=drivesdk
Device: Pinebook Pro 128GB No:246 / MainOS: Manjaro ARM
Godot and Flutter - creating something can be fun with the right tools!
Godot and Flutter - creating something can be fun with the right tools!