NVMe Adapter Ribbon Cable

[Kaythe]

It does fit, but it requires some folding. What I did was attached the ribbon cable to the 2 boards, then loosely started the 3 screws to retain the adapter board. Once the screws were started, I held the "fold" of the ribbon cable as I tightened the screws down.

Be mindful, that with the current adapter board, use of 80mm drives will require modifications, whereas 60 and 42mm drives do not.

Thanks, I was just a bit too chicken to fold it that much... Turned out the SSD I had here is actually a SATA one so I'll hold off on the extension for now but it's good too know the board is actually usable after all ^^"