06-02-2018, 06:37 AM
(06-01-2018, 04:14 PM)pfeerick Wrote: No problem, sharing is what the community is all aboutThat's what I'll be doing as well. Until I've cut out holes in the acrylic case for the heatsink, PI-2 bus, and PCI-e slot. I have to find a solution without sacrificing firmness and without sacrificing usage of the mounting hole (in the board) facing towards the open end of the PCI-e slot. I need the board and case in my hands for that.
For the moment, yes... it's just on some stand-offs to lift it off the table, and will be sat there for a while whilst it gets used, abused, and different stuff tested. I might then get the case that Luke just posted about for it, and put it to use as a beefy NAS and lightweight server.
Luke's case design will be a perfect fit for your use case.