06-29-2016, 09:43 PM
(06-27-2016, 02:02 PM)janeku Wrote: Hello. I got my Pine finallybut without ABS Case
.
At start I tried images suggested by PINE but no luck. They stuck at the boot after couple of minutes.
Then I tried Jessie's image. MARVELOUS. Fast and accurate.
I managed to log in in less than minute. My USB HUB work great with this image.
I have couple of Q's here:
1. I just can't find Jessie's explanation, something about expanding space on Sd card or similar. Looks like his first post is modified since my last log in here. Is this still valid operation to be done after booting up image or it is already automated ?
2. Regarding Iceweasel as a primary browser. It crashes (close) twice since I ran image, Is it due to lack of memory (at this moment I am using Maxell 8GB card, just for testing) or it is a known bug ?
3. Received push button, should be soldered on top of board, where it says POWER (next to RESET) or should I make melting of closed holes and put through board connectors and solder them from bottom side ? I must mention that these holes are already soldered.
I am fully supporting Jessie and his work.
Now I am going to test Android images but I think I will stuck at the same place as before with other images
Regards,
1. To expand the filesystem so you can access all of the space on your microSD card, run the resize_rootfs.sh script - ie.
Code:
sudo /usr/local/sbin/resize_rootfs.sh2. I can't help you with that one - but someone else on the forum did mention they had some issues with iceweasel crashing IIRC
3. The button is intended to be pressed onto the board from the top, and soldered on the bottom, if you intend to use it. It was left loose as some people wanted to be able to use a different button or mount it differently.
Hope you're enjoying your new board!