03-03-2022, 07:47 PM
I tried this release and it worked GREAT on the SD card! So I decided to flash it to the eMMC. It flashed fine but failed to boot. I disabled the splash image so I could see what was happening - see attached. It couldn't find the boot device, even though it's there. I'm currently using tow-boot flashed to SPI (also works great). I know it gets to the eMMC (I changed the armbianEnv.txt file to point to /dev/mmcblk2p1 and it complained about that too, so I know it's reading the /boot directory
).
I used dd to flash the device, and the contents look fine. Same dd command I used for the SD card I've been testing with.
The UUID it says it can't find is the correct one set for the partition. And even though it says it's dropping to the shell, I can't type anything (no, I don't have a serial UART cable). Don't know anything about hardware initialization process. Anyone have any idea where to look?
I used dd to flash the device, and the contents look fine. Same dd command I used for the SD card I've been testing with.
The UUID it says it can't find is the correct one set for the partition. And even though it says it's dropping to the shell, I can't type anything (no, I don't have a serial UART cable). Don't know anything about hardware initialization process. Anyone have any idea where to look?