02-28-2018, 10:45 AM
The two LEDs near the GbE PHY are the normal PHY LEDs you would have on a normal magjack/RJ47 socket, they can be configured via RTL8211E registers. The LED at the board edge it the 'System' LED you can use for whatever you want basically, e.g. heartbeat and is connected to PL7 GPIO as on the normal Pine64 boards... the LED on top of the SOPine module is the power LED for the AXP803 PMIC and just signals that it's primary input voltage is OK... the LED near the power connector is just a fixed power LED...
As for the USB ports, on Linux both are host ports... the USB-A is connected to USB0 and the micro-USB-A is connected to USB1, both are configured in host mode. You can use the micro-USB port with a host port adapter like for phones with micro-A ports...
As for the USB ports, on Linux both are host ports... the USB-A is connected to USB0 and the micro-USB-A is connected to USB1, both are configured in host mode. You can use the micro-USB port with a host port adapter like for phones with micro-A ports...
Come have a chat in the Pine IRC channel >>
