Pinecil Troubleshooting
#1
Hi,

I used my Pinecil yesterday for a couple hours and today it stopped working. Connected to the PinePower Desktop via USB-C, it just repeatedly blinks on and off. Occasionally it will turn on after replugging, but the temperature is incorrect (shows 450 C) and the soldering tip never gets hot. I tried to flash the firmware, but the Pinecil won't enter USB mode (holding the minus button, plugging in, and releasing minus button) and the Pinecil Firmware Updater doesn't show that it's connected. Any help here would be great!

Cheers
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Connecting a power supply to the Pinecil jon_bondy 1 187 02-29-2024, 07:37 PM
Last Post: Okedokey
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 2 647 01-31-2024, 12:34 AM
Last Post: suga7
Question Pinecil Tempaerature Reading jumps to Y400°C when active but stays normal when cold H3wastooshort 0 299 12-24-2023, 05:45 PM
Last Post: H3wastooshort
  Asus laptop power supply can also power Pinecil biketool 9 7,882 11-17-2023, 12:57 PM
Last Post: killingmesmalls
  Mass problem Pinecil V2 Harrysteed 0 558 11-02-2023, 09:11 AM
Last Post: Harrysteed
Question Pinecil v2 power cycles at higher voltages? clemon79 2 1,174 10-09-2023, 10:10 PM
Last Post: clemon79
  PD resets during heat up tip [Pinecil V2] Neitron4ik 2 1,435 10-09-2023, 01:22 AM
Last Post: Neitron4ik
  [Hackaday Article] All About USB-C: Pinecil Soldering Iron vajak 1 1,334 02-02-2023, 11:45 AM
Last Post: VaZso
  Brand new Pinecil v2 won't boot on PD jhutch 1 2,109 12-14-2022, 01:03 AM
Last Post: River
  Survey on Pinecil Tips, Please fill out River 0 1,196 11-06-2022, 02:43 AM
Last Post: River

Forum Jump:


Users browsing this thread: 1 Guest(s)