Hello. I got my Pine finally 
but without ABS Case 
.
At start I tried images suggested by PINE but no luck. They stuck at the boot after couple of minutes.
Then I tried Jessie's image. MARVELOUS. Fast and accurate.
I managed to log in in less than minute. My USB HUB work great with this image.
I have couple of Q's here:
1. I just can't find Jessie's explanation, something about expanding space on Sd card or similar. Looks like his first post is modified since my last log in here. Is this still valid operation to be done after booting up image or it is already automated ?
2. Regarding Iceweasel as a primary browser. It crashes (close) twice since I ran image, Is it due to lack of memory (at this moment I am using Maxell 8GB card, just for testing) or it is a known bug ?
3. Received push button, should be soldered on top of board, where it says POWER (next to RESET) or should I make melting of closed holes and put through board connectors and solder them from bottom side ? I must mention that these holes are already soldered.
I am fully supporting Jessie and his work.
Now I am going to test Android images but I think I will stuck at the same place as before with other images
Regards,
but without ABS Case .At start I tried images suggested by PINE but no luck. They stuck at the boot after couple of minutes.
Then I tried Jessie's image. MARVELOUS. Fast and accurate.
I managed to log in in less than minute. My USB HUB work great with this image.
I have couple of Q's here:
1. I just can't find Jessie's explanation, something about expanding space on Sd card or similar. Looks like his first post is modified since my last log in here. Is this still valid operation to be done after booting up image or it is already automated ?
2. Regarding Iceweasel as a primary browser. It crashes (close) twice since I ran image, Is it due to lack of memory (at this moment I am using Maxell 8GB card, just for testing) or it is a known bug ?
3. Received push button, should be soldered on top of board, where it says POWER (next to RESET) or should I make melting of closed holes and put through board connectors and solder them from bottom side ? I must mention that these holes are already soldered.
I am fully supporting Jessie and his work.
Now I am going to test Android images but I think I will stuck at the same place as before with other images
Regards,