PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Automate checking whether the Pinecil is still in stock

Automate checking whether the Pinecil is still in stock
Julius_GU
Pine Initiate
**
Joined: Dec 2020
Posts: 8

Reputation: 3
#4
02-03-2021, 06:54 AM
(02-01-2021, 08:45 PM)ImmortanJoe Wrote:
Code:
#!/usr/bin/python3

Code:
os.system("xdg-open "+url)
Those are good changes, I didn't really give machine independence a lot of thought when I wrote it.
I'm glad that this could serve as a basis, your project sounds really cool
  Reply


Messages In This Thread
RE: Automate checking whether the Pinecil is still in stock - by Julius_GU - 02-03-2021, 06:54 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Pinecil low temp mods? davidcoley 0 303 06-21-2026, 02:53 AM
Last Post: davidcoley
  my pinecil v2 is not working jagrav 0 747 04-17-2026, 06:28 AM
Last Post: jagrav
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 1 2,668 03-28-2026, 02:37 AM
Last Post: Juptin
  Pinecil v2: Use car battery for power? FZB 0 748 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 1,155 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 1,399 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,527 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 9,324 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 5,584 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil v2 issue autumnharris 0 1,601 05-15-2025, 01:35 AM
Last Post: autumnharris

Forum Jump:


Users browsing this thread: 1 Guest(s)