Hello,
I have probably bricked my Pinebook pro.
I flashed the SPI device.
Without the desired result; booting from the builtin M.2 drive
When I put it on I only see the red power LED flash for half a second and then nothing.
The system-board is consuming power because its getting warm.
After a long pres of 15 seconds the board is off again; the board is getting cooler again.
I tried to clear the SPI chip with rkdeveloptool
But I get an error:
./rkdeveloptool db rk3399_loader_spinor_v1.15.114.bin >>
The device does not support this operation!
Is there someone who knows how to repair this?
Freerk Jongsma
I have probably bricked my Pinebook pro.
I flashed the SPI device.
Without the desired result; booting from the builtin M.2 drive
When I put it on I only see the red power LED flash for half a second and then nothing.
The system-board is consuming power because its getting warm.
After a long pres of 15 seconds the board is off again; the board is getting cooler again.
I tried to clear the SPI chip with rkdeveloptool
But I get an error:
./rkdeveloptool db rk3399_loader_spinor_v1.15.114.bin >>
The device does not support this operation!
Is there someone who knows how to repair this?
Freerk Jongsma
