12-07-2019, 02:56 PM
(12-07-2019, 02:15 PM)tsys Wrote: .15 mm is probably not going to be a big deal. Should have really ordered 1.8 mm PCBs though. Guess we'll see in few weeks ¯\_(ツ)_/¯
=) Worst case, you will need to use the potential adapter/daughter board mating solution you identified earlier (short wire segments in the mating vias).
I think I may be making an order of your design after looking it over one more time. If so, I will buy you a cup of coffee! I haven't attempted soldering castellations or board joining through vias, so practice is a good idea.
