12-07-2019, 02:15 PM
(12-07-2019, 01:42 PM)hmuller Wrote: I haven't ordered from JLC but their standard PCB thickness is 1.6 mm according to their website. So a potential issue is that the adapter board may not provide enough clearance to get the daughter board cleanly (parallel) over the audio amp chips..15 mm is probably not going to be a big deal. Should have really ordered 1.8 mm PCBs though. Guess we'll see in few weeks ¯\_(ツ)_/¯
(12-07-2019, 02:01 PM)Arwen Wrote: Would it be possible to make a replacement NVMe board with the power chip, (and storage capacitor), on it?
Maybe a tiny heat sink for the power chip too.
If it also solved the installation problem from the original NVMe boards, I'd pay more for a clean solution like this.
Sure. Might try that next. Would be a lot easier to retrofit than replacing the main 3v3sys regulator.
