Pinebook Pro Initial Impressions

[bcnaz]

*x*x*x*x*

       NOT a production  FIX

                 **********

   BUT Maybe a "Mod Fix"

  ?  This adapter board only adapts the module to the ribbon cable
            There is NO circuitry on the rest of the adapter board.

       IF  a person could Hold the module against the adapter by the edges.....          

      **   You could CUT the end of the adapter board to clear the touch pad..

       I am Looking at the picture in the "WIKI"

         Not sure exactly what would be an acceptable method  ...
         as I know the module goes into the socket at an angle then it must be lowered to seat properly.
          Perhaps the heat sink pad I heard someone mention could be wrapped around it like tape  ???

           (That could be a "baling wire/duct tape"  solution  ?)

                               ***************************
                  "Cowboy Fix"

               That should gain you potentially a half an inch  

           Should be more than enough space to clear the touch pad that way
[/quote]