05-05-2019, 03:32 PM
Hey Guys and Gals,
So I recently acquired a Clusterboard and wanted to take it for a spin. But no luck so far...
When I tried to start it with a single SoPine inserted nothing happened, so - dismayed - I tried another one and got a response: The lights went on and I got approximately three seconds of Christmas Tree Action. After that: Nothing...
After reading on this Forum I tried a Xenial 3.10 Build and now I get at least a heartbeat on the SoPine I inserted! But still no lights on the switch. Not even a status light on the RJ45 Socket...
Now I am worried that the board might be fried.
Do you have any ideas?
(I'm still waiting for a USB/UART Adapter. Tried it with a DIY Arduino Thingy but that did not work. No UART Signal so far, or none detectable by the Arduino.)
So I recently acquired a Clusterboard and wanted to take it for a spin. But no luck so far...
When I tried to start it with a single SoPine inserted nothing happened, so - dismayed - I tried another one and got a response: The lights went on and I got approximately three seconds of Christmas Tree Action. After that: Nothing...
After reading on this Forum I tried a Xenial 3.10 Build and now I get at least a heartbeat on the SoPine I inserted! But still no lights on the switch. Not even a status light on the RJ45 Socket...
Now I am worried that the board might be fried.
Do you have any ideas?
(I'm still waiting for a USB/UART Adapter. Tried it with a DIY Arduino Thingy but that did not work. No UART Signal so far, or none detectable by the Arduino.)
