03-14-2019, 05:50 PM
I've recently acquired a clusterboard with some compute modules, along with a baseboard. I've verified the modules are operational via the baseboard, and boot via the clusterboard's serial terminal. I'm using the latest stable version of Armbian. The board is being powered via an external supply coming into the connector beside the coaxial power jack, to which I've soldered screw terminals. I've also tried the "official?" brick supplied from Ameridroid.
I'm having trouble getting the modules to talk to the network. I've assigned the modules static IP addresses within Armbian, and it appears to be correct when I check it. The yellow LEDs are blinking as if there is network traffic, and the green are all blinking in unison save the slot(s) where modules are installed. If I tell a particular module to halt, the green LED stops blinking.
Is there something I'm missing? I've read about some changes to network timing in other threads, but I'm not sure where to go with this.
I'm having trouble getting the modules to talk to the network. I've assigned the modules static IP addresses within Armbian, and it appears to be correct when I check it. The yellow LEDs are blinking as if there is network traffic, and the green are all blinking in unison save the slot(s) where modules are installed. If I tell a particular module to halt, the green LED stops blinking.
Is there something I'm missing? I've read about some changes to network timing in other threads, but I'm not sure where to go with this.
