Not sure whether this is the right place for this topic. Please excuse me if this is not so.
I'm using the HardKernel microSD to eMMC adapter (connected to a USB-2 card reader) with the Foresee NCEMASLG-64G 64 eMMC module that I purchased from the Pine64 store along with the RockPro64 v2.1. After writing the 3 GB uncompressed RockPro64 LXDE image on the eMMC, the "Etcher" utility starts verifying the image and gets stuck at 16% and after some time I get "EIO: i/o error, read error". My second attempt gave the same error, but this time as early as at 8%. And my third attempt – at 9%. I.e., the error occurs each time at a different place. I have previously used the same adapter with an 16 GB eMMC module for the ODROID-XU4 and it worked normally. Is this a sign of a bad eMMC module, or something else? I can try booting the board from a slow microSD card and then writing the image from there if the eMMC is OK. Thanks a lot for your help!
I'm using the HardKernel microSD to eMMC adapter (connected to a USB-2 card reader) with the Foresee NCEMASLG-64G 64 eMMC module that I purchased from the Pine64 store along with the RockPro64 v2.1. After writing the 3 GB uncompressed RockPro64 LXDE image on the eMMC, the "Etcher" utility starts verifying the image and gets stuck at 16% and after some time I get "EIO: i/o error, read error". My second attempt gave the same error, but this time as early as at 8%. And my third attempt – at 9%. I.e., the error occurs each time at a different place. I have previously used the same adapter with an 16 GB eMMC module for the ODROID-XU4 and it worked normally. Is this a sign of a bad eMMC module, or something else? I can try booting the board from a slow microSD card and then writing the image from there if the eMMC is OK. Thanks a lot for your help!