Hello,
I am trying to use the "Android 7.1.2 Stock Image using DD method [eMMC Boot] [20180518]" image to write to my 64GB eMMC module.
I have the USB adapter for eMMC and used the Pine64 installer to write the image to the eMMC module.
The image wrote and was verified successfully by the Pine64 installer.
When I put the eMMC module onto the board and boot, the light comes on, but nothing else happens. I left it for 15 minutes then switched it off and retried downloading and writing the image again. - this did not work either.
Any suggestions?
Thank you in advance.
Christian
Smart DIY Tech
www.smartdiytech.com
I am trying to use the "Android 7.1.2 Stock Image using DD method [eMMC Boot] [20180518]" image to write to my 64GB eMMC module.
I have the USB adapter for eMMC and used the Pine64 installer to write the image to the eMMC module.
The image wrote and was verified successfully by the Pine64 installer.
When I put the eMMC module onto the board and boot, the light comes on, but nothing else happens. I left it for 15 minutes then switched it off and retried downloading and writing the image again. - this did not work either.
Any suggestions?
Thank you in advance.
Christian
Smart DIY Tech
www.smartdiytech.com