(05-16-2018, 04:38 PM)evilbunny Wrote: http://files.pine64.org/doc/clusterboard...header.jpg
And on that diagram, since there are four different UARTs mentioned, you want pins 6 (GND), 7 (TX) and 8 (RX) for the serial console...
And keep in mind that pin 1 is at the front of the board (i.e. were the USB ports all are) when looking at the pinout document, else you'll plug your cable in back to front and not much will happen...
![Wink Wink](https://forum.pine64.org/images/smilies/wink.png)