04-06-2018, 01:47 PM
Regarding the mounting holes, I've found that the M3 screws I have work without problem. Taking a micrometer to them they were about 2.9mm, so I think within normal tolerances. 1/8" rod will not fit.
Looking at a couple examples for the standard, they showed .156" and .16" - almost 4mm. I wonder if this is to accommodate #6 or M4 screws. For what it's worth, I've noticed the older orange pi boards used the 3mm mounting holes, whereas on the orange pi one+ they're closer to 4mm.
Looking at a couple examples for the standard, they showed .156" and .16" - almost 4mm. I wonder if this is to accommodate #6 or M4 screws. For what it's worth, I've noticed the older orange pi boards used the 3mm mounting holes, whereas on the orange pi one+ they're closer to 4mm.
