09-22-2017, 02:09 PM
Kickstarter backer, finally getting to playing with my A64+ 2gb
Using the new Etcher image burner on a Transcend 300x 16gb card UHS-1
No matter what image I use (Android, Linux, RemixOS, etc.), won't boot.
Power supply is a 5V 2.5A power supply I use with my Raspberry Pi 3 which works fine
Symptoms:
Red LED works/on when USB power is plugged in
HDMI out makes the monitor turn on, then off because 'no signal is detected', turns back on, turn off no signal -- keeps repeating
I'm unsure if this is power supply, memory card, or simply bunk A64 related.
Any help?
Using the new Etcher image burner on a Transcend 300x 16gb card UHS-1
No matter what image I use (Android, Linux, RemixOS, etc.), won't boot.
Power supply is a 5V 2.5A power supply I use with my Raspberry Pi 3 which works fine
Symptoms:
Red LED works/on when USB power is plugged in
HDMI out makes the monitor turn on, then off because 'no signal is detected', turns back on, turn off no signal -- keeps repeating
I'm unsure if this is power supply, memory card, or simply bunk A64 related.
Any help?
