09-03-2016, 03:19 AM
(09-03-2016, 02:50 AM)nesalot Wrote: Hey guys.
After hours of reformatting the card with different versions and trying different things I finally got my LCD screen to display Andriod. All it took was for me to remove the WIFI module and start it up and poof the LCD started right up. Buut this things a paper weight if I cant get it on a network so I turned it off and put the WIFI module back on making sure that 13,14,15, 16 all lines up correctly, I even saw on another post a how to on installing the wifi module so I know that it on their correctly. The LCD screen wont even come on while the WIFI module is attached, the red light on the pine will blink but nothing on the LCD, as soon as I turn the pine off and remove the module, boom works perfect again. I am using the power supply that came with the pine in the kickstarter. Anyone have any suggestions or help, or is this just a bad wifi module?
PS, I accidently had the WIFI module flipped around and the numbers not aligned and the LCD turned on, i got really excited but Andriod didnt recognize the module, i'm guessing because it was like it wasn't even installed.
Thanks in advance.
Hmm. It could be a power draw issue, that the supplied PSU cannot support both the Pine and the LCD touchscreen (which would be a bit of an oversight).
See also this similar thread, though it has no resolution.
My suggestions would be to try the official 5V 2.5A power supply meant for the Raspberry Pi 3 or try powering the Pine and connected touchscreen via the Euler Bus, though this process is somewhat more involved.
