05-15-2025, 10:41 AM
Mine still works fine, and having also read other reports I assume that the "crippling" noise also comes from electromechanics in the inductor, by regulating power.
|
Crippling noise from inside pinecil during a few minutes high power soldering.
|
| Messages In This Thread |
|
Crippling noise from inside pinecil during a few minutes high power soldering. - by dreieck - 10-03-2023, 05:51 AM
RE: Crippling noise from inside pinecil during a few minutes high power soldering. - by Neitron4ik - 10-09-2023, 01:28 AM
RE: Crippling noise from inside pinecil during a few minutes high power soldering. - by suga7 - 01-31-2024, 12:34 AM
RE: Crippling noise from inside pinecil during a few minutes high power soldering. - by dreieck - 05-15-2025, 10:41 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| my pinecil v2 is not working | jagrav | 0 | 429 |
04-17-2026, 06:28 AM Last Post: jagrav |
|
| Pinecil V2 doesn’t power on under any circumstances | BigCarrotLeaf | 1 | 2,429 |
03-28-2026, 02:37 AM Last Post: Juptin |
|
| Pinecil v2: Use car battery for power? | FZB | 0 | 564 |
03-02-2026, 09:56 AM Last Post: FZB |
|
| Is Vector3d.shop a legitimate pinecil reseller? | jamespo | 0 | 975 |
12-03-2025, 07:40 AM Last Post: jamespo |
|
| Minimum temperature Pinecil | pschalkwijk | 1 | 1,196 |
10-16-2025, 10:40 PM Last Post: tllim |
|
| Pinecil v2 not reaching 20v … | Escape75 | 0 | 4,370 |
09-23-2025, 09:25 PM Last Post: Escape75 |
|
| Pinecil v2 tip screw temperature | Minuen | 0 | 9,123 |
06-23-2025, 06:38 AM Last Post: Minuen |
|
| Pinecil v2 issue | autumnharris | 0 | 1,435 |
05-15-2025, 01:35 AM Last Post: autumnharris |
|
| Pinecil constantly cutting out | WroughtIron | 1 | 3,211 |
01-16-2025, 02:20 AM Last Post: D4veC4rter |
|
|
Pinecil is working with 5v but nothing else!! | MizterPink | 1 | 2,244 |
01-07-2025, 03:59 PM Last Post: MizterPink |
Users browsing this thread: 1 Guest(s)