PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Pinecil v2 power cycles at higher voltages?

Pinecil v2 power cycles at higher voltages?
RevAngel
Pine Initiate
**
Joined: Aug 2024
Posts: 2

Reputation: 0
#4
08-10-2024, 05:47 AM
pinecil v2 with latest firmware and a ugreen nexode 140W. Goes up to 28.3 Volts and therefore heats up to max 420 degrees in 4 seconds!
  Reply


Messages In This Thread
RE: Pinecil v2 power cycles at higher voltages? - by RevAngel - 08-10-2024, 05:47 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  my pinecil v2 is not working jagrav 0 355 04-17-2026, 06:28 AM
Last Post: jagrav
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 1 2,391 03-28-2026, 02:37 AM
Last Post: Juptin
  Pinecil v2: Use car battery for power? FZB 0 528 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 951 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 1,159 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,353 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 9,101 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 5,227 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil v2 issue autumnharris 0 1,420 05-15-2025, 01:35 AM
Last Post: autumnharris
  Pinecil constantly cutting out WroughtIron 1 3,171 01-16-2025, 02:20 AM
Last Post: D4veC4rter

Forum Jump:


Users browsing this thread: 1 Guest(s)