Crippling noise from inside pinecil during a few minutes high power soldering.

[suga7]

Ahoj,

I just had a "high power" soldering job with my Pinecil V2 (power supply: 65W USB C PD; soldering task: Thin steel surface) where I had the pinecil set to maximum temperature and constantliy heating the piece where I wanted to solder.

After some time (2 minutes or so) I heard some noises from inside the pinecil. It did sound a bit crippling, like boiling stuff escaping some enclosure, or so.

I immediately disconnected power supply.

Outside of the pinecil, I felt not anywhere hotness; after disassembling (which took some time where parts can cool down) neither.

Has anyone observed similar things? Is the Pinecil safe to use long time at high power (will safe-protect if too long)? Any thoughts on what I have observed?

I now did re-test without or with thermal load, and in both cases there are two types of noises: dinosaur game
* Some regular noise which sounds like coming from driving the power output FET (PWM noise),
* rarely, some irregular noise as described above.

The second one _may_ also be some noise related to regular operation, emitted by the small inductor on the PCB, but I cannot discern.

Does the regulation sometimes involve "very irregular" pulses through the power FET/ the inductor?

Regards!

The noises you heard from inside the Pinecil during your high-power soldering job could be attributed to the normal operation of the device. When a soldering iron is operating at its maximum temperature and providing constant heat to a piece, it can generate some audible noises, including PWM noise from driving the power output FET. Additionally, the irregular noise you mentioned could potentially be related to the small inductor on the PCB. While it's difficult to discern the exact cause without further investigation, it's worth noting that these noises might be within the normal range of operation for the Pinecil. However, if you have concerns about the safety of using the Pinecil for extended periods at high power, it's advisable to reach out to the manufacturer or consult the product documentation for guidance on its recommended usage and any built-in safety mechanisms.