PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   PD resets during heat up tip [Pinecil V2]

PD resets during heat up tip [Pinecil V2]
Neitron4ik
Pine Initiate
**
Joined: May 2023
Posts: 6

Reputation: 0
#2
08-11-2023, 11:48 PM
If charger drops to 15V PD mode, it works stable.
  Reply


Messages In This Thread
RE: PD resets during heat up tip [Pinecil V2] - by Neitron4ik - 08-11-2023, 11:48 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Pinecil V2 doesn’t power on under any circumstances BigCarrotLeaf 1 2,132 03-28-2026, 02:37 AM
Last Post: Juptin
  Pinecil v2: Use car battery for power? FZB 0 375 03-02-2026, 09:56 AM
Last Post: FZB
  Is Vector3d.shop a legitimate pinecil reseller? jamespo 0 783 12-03-2025, 07:40 AM
Last Post: jamespo
  Minimum temperature Pinecil pschalkwijk 1 994 10-16-2025, 10:40 PM
Last Post: tllim
  Pinecil v2 not reaching 20v … Escape75 0 4,252 09-23-2025, 09:25 PM
Last Post: Escape75
  Pinecil v2 tip screw temperature Minuen 0 8,959 06-23-2025, 06:38 AM
Last Post: Minuen
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 3 4,910 05-15-2025, 10:41 AM
Last Post: dreieck
  Pinecil v2 issue autumnharris 0 1,308 05-15-2025, 01:35 AM
Last Post: autumnharris
  Pinecil constantly cutting out WroughtIron 1 2,905 01-16-2025, 02:20 AM
Last Post: D4veC4rter
Exclamation Pinecil is working with 5v but nothing else!! MizterPink 1 2,008 01-07-2025, 03:59 PM
Last Post: MizterPink

Forum Jump:


Users browsing this thread: 1 Guest(s)