Pinetime almost dead... only shows Infinitime logo.
02-10-2023, 02:43 PM
Hi everyone! I faced the same issue. I was running a pine watch with 1.11.0 firmware, but then after my toddler found it they start to show infinitime logo.
I followed steps described by @barray but my GadgetBrige refuses to connect to a pine watch. It sees it, it pairs with it, but refuses to connect. And firmware update via GadgetBriges is not possible without connected device.
Then I installed ITD (v1.0.0) software on my laptop. And my laptop was able to connect to a pine watch. But I can not upgrade a firmware.
I need your help, because I think miss something very obvious, but I do not know what exactly.
I followed steps described by @barray but my GadgetBrige refuses to connect to a pine watch. It sees it, it pairs with it, but refuses to connect. And firmware update via GadgetBriges is not possible without connected device.
Then I installed ITD (v1.0.0) software on my laptop. And my laptop was able to connect to a pine watch. But I can not upgrade a firmware.
Code:
itdctl firmware version
0.14.1
itctl firmware upgrade /home/alex/Downloads/pinetime-mcuboot-app-dfu-1.11.0.zip
Upgrade command requires either archive or init packet and firmware.I need your help, because I think miss something very obvious, but I do not know what exactly.