09-21-2022, 01:44 PM
Hi,
I have a serious trouble with my Pinebook pro. There is no boot possible even on SD card.
Initial state : Pinebook pro boot well on emmc with Manjaro (there were conflicts for updates in this older version of Manjaro, that’s why I wanted a new installation )
1) I boot on SD card with a Manjaro.
2) I update manjaro-flash on the SD card and run it.
3) I put a USB key that contains the image Manjaro-ARM-kde-plasma-pbpro-22.08.img.xz
4) I tell arm-flash the location of the image and click on install. It runs and indicates a progress of the installation on the emmc (several gigabytes).
5) I turn off the machine and remove the SDCard.
6) I turn on the Pinebook pro, and absolutely nothing is happening, no LED lights up, everything stays off.
So I decided to remove the emmc memory and boot on the previous SDCard.
I did several tests by pressing the power button for a long time or not.
I also pressed the reset button on the motherboard.
The computer seems dead because there is not even a light that turns on (I specify that it is plugged into an electrical outlet).
Can a reinstall be forced with UART mode and serial cable for example?
Thank you if you have an idea.
I have a serious trouble with my Pinebook pro. There is no boot possible even on SD card.
Initial state : Pinebook pro boot well on emmc with Manjaro (there were conflicts for updates in this older version of Manjaro, that’s why I wanted a new installation )
1) I boot on SD card with a Manjaro.
2) I update manjaro-flash on the SD card and run it.
3) I put a USB key that contains the image Manjaro-ARM-kde-plasma-pbpro-22.08.img.xz
4) I tell arm-flash the location of the image and click on install. It runs and indicates a progress of the installation on the emmc (several gigabytes).
5) I turn off the machine and remove the SDCard.
6) I turn on the Pinebook pro, and absolutely nothing is happening, no LED lights up, everything stays off.
So I decided to remove the emmc memory and boot on the previous SDCard.
I did several tests by pressing the power button for a long time or not.
I also pressed the reset button on the motherboard.
The computer seems dead because there is not even a light that turns on (I specify that it is plugged into an electrical outlet).
Can a reinstall be forced with UART mode and serial cable for example?
Thank you if you have an idea.