07-18-2022, 03:57 AM
Hi all,
my brand new pinetime is stuck at the "infinitime logo" after 2-3 days.
I've used gadgetbrige to flash the 1.9.0 firmware as soon as the watch arrived. Everything was fine for about 2 days. After that the "inititime" logo appeared and i got stuck there. I've discharged the watch, read some help request so i went in the blue recovery and then in the red one and got it flashed again. Seemed fine for about a day and then "infinitime logo" again.
Tried to flash it again with 1.9.0 or anything but nothing worked. Rebooted phone, tried gadgetbrige, nrf connect, different boot (green, blue and red) but i can't associate the watch with gadgetbrige anymore (no entry there so no flash) and with nrf connect i get a "starting DFU, disconnecting" with nothing done apparently (uploading the firmware usually require about a minute).
Any idea on how i can recover from here?
Thanks!
my brand new pinetime is stuck at the "infinitime logo" after 2-3 days.
I've used gadgetbrige to flash the 1.9.0 firmware as soon as the watch arrived. Everything was fine for about 2 days. After that the "inititime" logo appeared and i got stuck there. I've discharged the watch, read some help request so i went in the blue recovery and then in the red one and got it flashed again. Seemed fine for about a day and then "infinitime logo" again.
Tried to flash it again with 1.9.0 or anything but nothing worked. Rebooted phone, tried gadgetbrige, nrf connect, different boot (green, blue and red) but i can't associate the watch with gadgetbrige anymore (no entry there so no flash) and with nrf connect i get a "starting DFU, disconnecting" with nothing done apparently (uploading the firmware usually require about a minute).
Any idea on how i can recover from here?
Thanks!