Just purchased a used PBP (with no eMMC!) - any tips for a new user?
Seems pretty clear to me
----
mmc1 is current device
** NO partition table - mmc 1 **
Couldn't find partition mmc 1:1
Card did not respond to voltage select! -110
----
mmc1 is sd card, uboot is complaining that it can't read it
This is somewhat typical of manjaro's crappy mainline uboot
If the card is NOT high quality, get another card, this is important when running OS from sd card
Or,, on another linux box, download a BSP uboot, manjaro's will do,
rip apart the package and manually write idbloader, uboot and trust to correct places on sd
Best practice is blank 1st 16M first (/dev/zero), backup mbr first or make a note of the sectors (before blanking)
The behavior re usb boot is exactly as expected
----
Note: uboot MUST match the device, ie rk3399 pinebookpro, a uboot for any other device will NOT work
----
mmc1 is current device
** NO partition table - mmc 1 **
Couldn't find partition mmc 1:1
Card did not respond to voltage select! -110
----
mmc1 is sd card, uboot is complaining that it can't read it
This is somewhat typical of manjaro's crappy mainline uboot
If the card is NOT high quality, get another card, this is important when running OS from sd card
Or,, on another linux box, download a BSP uboot, manjaro's will do,
rip apart the package and manually write idbloader, uboot and trust to correct places on sd
Best practice is blank 1st 16M first (/dev/zero), backup mbr first or make a note of the sectors (before blanking)
The behavior re usb boot is exactly as expected
----
Note: uboot MUST match the device, ie rk3399 pinebookpro, a uboot for any other device will NOT work
