Pinetime almost dead... only shows Infinitime logo.
10-03-2021, 04:19 PM
(This post was last modified: 10-03-2021, 04:19 PM by lightweight.)
My Pinetime was running fine for weeks after upgrading the new watch from Infinitime 1.2 to 1.3 (using GadgetBridge on my Lineage phone). Only problem I noticed was difficulty reconnecting to my phone.
But one night, a couple weeks ago, I noticed the watch had shut down. I restarted it with the power button, saw the 1.0.0 boot screen with pinecone, which filled with green (as normal) and then switched to Infinitime logo. The watch was otherwise completely unresponsive. Only thing I've been able to do is long-press the button to force a restart. Unable to connect with it via GadgetBridge...
I let the battery run out all the way (left it like that for a few days to see if it might reset thing for it to go completely flat - no luck so far!).
If I charge it briefly, I can see the same behaviour. The only other behaviour I see is that when I long-press and force a reboot, if I continue holding the button, the green progressing up the pinecone turns blue (if I let got at that point, it progresses in blue and goes to the Infinitime logo, same lack of responsiveness) and if i continue holding it turns red just before completing. In all cases, it then shifts to the Infinitime logo and is otherwise unresponsive.
Anyone else see this? Any thoughts on how to recover?
But one night, a couple weeks ago, I noticed the watch had shut down. I restarted it with the power button, saw the 1.0.0 boot screen with pinecone, which filled with green (as normal) and then switched to Infinitime logo. The watch was otherwise completely unresponsive. Only thing I've been able to do is long-press the button to force a restart. Unable to connect with it via GadgetBridge...
I let the battery run out all the way (left it like that for a few days to see if it might reset thing for it to go completely flat - no luck so far!).
If I charge it briefly, I can see the same behaviour. The only other behaviour I see is that when I long-press and force a reboot, if I continue holding the button, the green progressing up the pinecone turns blue (if I let got at that point, it progresses in blue and goes to the Infinitime logo, same lack of responsiveness) and if i continue holding it turns red just before completing. In all cases, it then shifts to the Infinitime logo and is otherwise unresponsive.
Anyone else see this? Any thoughts on how to recover?