Hello,
I recently got my PINETAB-V. I connected the USB-C power cable and pressed the power button for exactly 2 seconds, as instructed in the manual.
It looked like the OS was about to boot, but the following message has been repeating for over 4 hours:
`[21966.202233] [WARNING][BB]Skip gain error setting in scan status`
According to the documentation at [https://pine64.org/documentation/PineTab-V/\_full/]
> The 2nd batch of PineTab-V devices ship with a Debian Bookworm image from StarFive.
So I was expecting the OS to be pre-installed — is that not the case?
I recently got my PINETAB-V. I connected the USB-C power cable and pressed the power button for exactly 2 seconds, as instructed in the manual.
It looked like the OS was about to boot, but the following message has been repeating for over 4 hours:
`[21966.202233] [WARNING][BB]Skip gain error setting in scan status`
According to the documentation at [https://pine64.org/documentation/PineTab-V/\_full/]
> The 2nd batch of PineTab-V devices ship with a Debian Bookworm image from StarFive.
So I was expecting the OS to be pre-installed — is that not the case?
