Needed -- Clarification of Boot SequenceInstructions
#1
The PPP wiki describes the permanent and a temporary boot sequence.  I find the wiki to conflict itself.  I think many users are showing confusion and posting numerous threads because they don't understand what is being told to them.  There is also another batch of new user coming. Toward that end, I have extracted the Boot Sequence discussion from the wiki.  I have posted my comments (in red) next to each line.  Hopefully this can get to the root of alot of confusion if someone can provide the mods.  If I have made bad interpretations, I'd like to know.

Boot Order:
On the PinePhone Pro the eMMC (the internal storage of the phone) has a higher boot priority than the microSD card (see boot sequence details for details regarding the boot sequence). That behavior is in contrast to the original PinePhone with the Allwinner A64 SoC, where the microSD card has a higher boot priority. (OK)

The Explorer Edition comes with a modified U-Boot pointing to the microSD card pre-installed to the eMMC. (OK, but no reason why)
The microSD card can be (temporarily) booted instead of the pre-installed operating system, when the power key is shortly held at boot. (Says temporary sd boot)
To always boot from the microSD card it is recommended to wipe U-Boot from the eMMC.(This conflicts with 1st line above.  Removing the temporary UBoot would make it go back to eMMC, it looks to me.  Also, does not say specifically what file to remove.
When the pre-installed bootloader was overwritten with a bootloader without such a configuration, the RE button underneath the back cover of the phone can also be used to temporarily bypass the eMMC. (what does "was" mean?  What configuration, does this mean a configuration with the temporary UBoot removed? I think this says the RE button can also make device boot from SD.  Does not say how to apply RE; one press-then power on, hold down, hold down and press power on?)
The button may however only be pressed shortly for a few seconds during boot, otherwise the eMMC won't be initialized in the operating system.  ( This seems to conflict with previous statement and says hold RE for a few seconds makes boot to eMMC.  Previous statement said it would bypass eMMC and boot to sd.)

Also, further down in wiki, in a yellow box. 

Due to the specific boot order it is currently strongly recommended to boot from the microSD card only. Please ask in the community chat if you have any questions regarding the installation  (no reason given as to why to boot from SD and not the eMMC that any phone should run from.  Also does not say this is a temporary thing.)

Thanks for reading this and also for any clarifications.      tom kosvic
  Reply


Messages In This Thread
Needed -- Clarification of Boot SequenceInstructions - by tckosvic - 03-04-2022, 10:48 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Can't boot Pinephone Pro into Factory Test Build for Hardware Checking jydoxcen 3 839 02-17-2024, 04:04 AM
Last Post: fxc
  Mobian + tow boot + emmc flash = boot loop spropine 4 3,292 12-31-2022, 09:14 AM
Last Post: mburns
  Need to re-write U-boot from Pinephone pro currently in mass rom mode wolverine1 6 2,991 11-20-2022, 05:58 AM
Last Post: wibble
  Tow-Boot issue Barugon 1 1,386 10-22-2022, 03:22 AM
Last Post: AndrewBlackmiller
  pinephone pro boot: kernel image not aligned on 64k boundary kmerfeld 2 2,089 08-15-2022, 10:35 AM
Last Post: ajaso
  pinephone pro don’t boot anymore :/ (I erased bootloader by mistake) elode 9 5,029 06-20-2022, 11:16 AM
Last Post: elode
Information Fix PinePhone Pro when unable to boot due to drained battery butjar 7 6,085 05-21-2022, 01:24 PM
Last Post: 98cwitr
  My new Pinephone Pro does not boot any more jlioret 3 2,622 05-21-2022, 12:08 PM
Last Post: 98cwitr
  Tow-Boot on PP vasir 1 1,320 04-28-2022, 05:22 PM
Last Post: vasir
  Boot order Barugon 13 8,162 03-11-2022, 09:16 AM
Last Post: kaida

Forum Jump:


Users browsing this thread: 1 Guest(s)