Power Ribbon for LCD Display

[Plot]

Hi,
I put together my PINE with the LCD Touchpanel and everything works great. However now I have the enclosure and the original power ribbon is to short.... Does anyone know where I can get a longer power ribbon? I tried eBay and got a new one but now the Pine doesn't power on with it. I switched it out to the old ribbon and it powers on fine so I'm pretty sure I just got the wrong ribbon.

It says AWM 20624 80C 60V VW-1 on the ribbon. Any help would be appreciated.

[dkryder]

i bought a a cable & extender on ebay .
http://www.ebay.com/itm/FFC-FPC-30-pin-0...1985309073
this worked. i also bought just a ffc cable on digikey,
http://www.digikey.cz/product-detail/en/...ND/4573405
and that works.
the one from ebay also has AWM 20264 80C 60V VW-1 on ribbon so i do not think that your piece with that marking means all pieces with that marking do not work. i'd suggest to unhook everything, hook back up, perhaps burn a new sd card. just go from start and try again.

[Bluphire]

You could always just get the C4 Labs LCD enclosure That way you won't need a longer cable AND you can take the enclosure apart if you needed to.

C4 Labs LCD enclosure

Matt

[dkryder]

You could always just get the C4 Labs LCD enclosure That way you won't need a longer cable AND you can take the enclosure apart if you needed to.

C4 Labs LCD enclosure

Matt

that case is very good looking but fails to support the use of the multiport board or the dev board.