Power Ribbon for LCD Display - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: General (https://forum.pine64.org/forumdisplay.php?fid=1) +--- Forum: Getting Started (https://forum.pine64.org/forumdisplay.php?fid=21) +--- Thread: Power Ribbon for LCD Display (/showthread.php?tid=2429) |
Power Ribbon for LCD Display - Plot - 10-22-2016 Hi, I put together my PINE with the LCD Touchpanel and everything works great. However now I have the enclosure and the original power ribbon is to short.... Does anyone know where I can get a longer power ribbon? I tried eBay and got a new one but now the Pine doesn't power on with it. I switched it out to the old ribbon and it powers on fine so I'm pretty sure I just got the wrong ribbon. It says AWM 20624 80C 60V VW-1 on the ribbon. Any help would be appreciated. RE: Power Ribbon for LCD Display - dkryder - 10-22-2016 i bought a a cable & extender on ebay . http://www.ebay.com/itm/FFC-FPC-30-pin-0-5mm-Pitch-Ribbon-Cable-line-ZIF-HDD-Adaptor-extend-connector-/151985309073 this worked. i also bought just a ffc cable on digikey, http://www.digikey.cz/product-detail/en/wurth-electronics-inc/687630152002/732-5177-ND/4573405 and that works. the one from ebay also has AWM 20264 80C 60V VW-1 on ribbon so i do not think that your piece with that marking means all pieces with that marking do not work. i'd suggest to unhook everything, hook back up, perhaps burn a new sd card. just go from start and try again. RE: Power Ribbon for LCD Display - Bluphire - 10-23-2016 You could always just get the C4 Labs LCD enclosure That way you won't need a longer cable AND you can take the enclosure apart if you needed to. C4 Labs LCD enclosure Matt RE: Power Ribbon for LCD Display - dkryder - 10-23-2016 (10-23-2016, 07:42 AM)Bluphire Wrote: You could always just get the C4 Labs LCD enclosure That way you won't need a longer cable AND you can take the enclosure apart if you needed to. that case is very good looking but fails to support the use of the multiport board or the dev board. |