PBP won't boot (no amber or green LED)
04-12-2021, 10:36 AM
>I am not sure what you mean by this: (obviously the 'bad' uboot MUST be removed first)
Wherever your failed,, wrong arch write went to,,,likely emmc
(In my case, 10 months ago, I removed SD, but it was still dead, until 20s press)
So, remove or disable (note, instructions are a bit backwards, unless it has been corrected)
(enabled = switch enabled = shorted = emmc has no clock = emmc disabled)
Easier to remove, no confusion possible
Even if it is removed, you may have to do 20s press,, somehow it remembers bad config
(or disconnect battery for ?? _ 1 hour _ ??)
Wherever your failed,, wrong arch write went to,,,likely emmc
(In my case, 10 months ago, I removed SD, but it was still dead, until 20s press)
So, remove or disable (note, instructions are a bit backwards, unless it has been corrected)
(enabled = switch enabled = shorted = emmc has no clock = emmc disabled)
Easier to remove, no confusion possible
Even if it is removed, you may have to do 20s press,, somehow it remembers bad config
(or disconnect battery for ?? _ 1 hour _ ??)
