03-18-2021, 11:07 AM
(03-17-2021, 02:31 PM)Pelecanus Wrote: The following worked for me:
- Take a screenshot of the QR-code
- Install the zbar-tools
- Run the following command to scan the QR-code:
zbarimg <path to the screenshot of the QR-code>
- In Axolotl go to the settings, add a new device and paste the result of the previous step.
That is so brillant! And completely impossible to figure out by oneself.
It worked fine till the very last step, the pressing of "Add" --my Axolotl will not add the device just like it does not add any new adresses that I enter.