128GB eMMC support

[dgkPBP]

Just re-downloaded 20.08, re-flashed, installed; no joy. It goes through all the configuration questions and reboots. I get three solid lines about a quarter inch wide from top to bottom of the screen; kind of like the logo is streched out. 

However, when I power it off and reboot, I get the manjaro logo; spinning dots  then it stops. Wait about a minute+, and I get the logon!

I can logon ok. Power down and back up OK.

Strange.

OK, the 128GB eMMC is working...but if I try to reboot from the running system, it hangs with a distorted logo (three lines from top to bottom of screen). If I manually power down, it will boot up just fine.

It also will not boot from a USB or SD. USB does nothing and the SD will hang wilh spinning dots. If I hit escape, I get a blank screen with ablinking cursor. IF I power down, remove the SD card and boot, it works fine.

I guess I can live with it, but it's troubling. I'd love to see a diagnostic image we could boot and run basic tests (memory test, re-flash boot, etc).

Thanks.